FIK-313-0021 Twinflex sound point in red. A sounder with 85dB output, three sound patterns and inbuilt ‘End of Line’ set by DIL switch. Supplied complete with back box and flush adaptor plate.
The Twinflex Soundpoint unit allows for audible indication when the system enters an alarm condition. This device is compatible with the Twinflex 2-wire range of Fire Alarm equipment and comprises a 2-wire zone-powered sounder. You can install this device on the same zone as the Multipoint detector/sounder and associated Twinflex devices.
The Sounder must be installed in compliance with the control panel installation manual. The installation must also meet the requirements of any local authority. For maximum performance the sounder should be installed in compliance to BS5839 Pt1 : 2002 + A2 : 2008. Fike recommends spacing of sounders in accordance with BS5839 Pt1. For more specific information regarding sounder spacing, placement and special applications please refer to BS5839 Pt1 : 2002 + A2 : 2008.
Surface Mounting
Fix the surface back box to a flat vertical surface using at least two of the four mounting holes provided. Drill the back box to allow cable access as required. A 20mm hole is already provided at the rear. Connect zone cabling to the terminals in the back box.
Flush Mounting
Flush mount the Soundpoint using the optional adaptor plate combined with any standard single gang flush mounting back box with a minimum internal depth of 47mm.
After installing the back box securely, attach the adaptor plate using the two screws provided, and terminate your cables directly into a flying terminal block.
