Tag Archives: pair

Jan 08

Turn any electrical outlet into a high-speed network connection

With the TM-600 HP you can extend your home network by using electrical sockets. Forget about drilling and rewiring cable throughout your house, with the TM-600 HP you can have internet anywhere in the house (on the same circuit) in a simple and convenient plug ‘n’ play system with no set up required.

Complying with the latest HomePlug AV2 standard, the TM-600 HP gives you a data transmission speed of up to 600Mbps, together with the built-in QoS that gives bandwidth intensive and sensitive applications a higher priority to remain stable and fast.

Forget Wireless

No need to worry about wireless signal strength and walls reducing signal quality.

Simply Plug ‘n’ Play

Connect your router into one adapter and plug the second adapter into another power outlet and you are ready to go!

HD Multimedia Streaming

Connect your Internet-ready TV, Blu-ray™ player, IPTV set-top box or gaming console through any power outlet in your property for super-fast HD transfer speeds.

Secure

With its powerful 128-bit AES encryption, your network is secure and protected. Simply press the Pair button on each unit to securely connect to each other.

*600Mbps is the maximum theoretical Powerline data rate. Actual throughput will vary depending on environment.

Mar 29

Materials needed:  CAT5/5e/6 Cable, RJ45 Plugs, Crimping Tool for RJ45 Plugs, RJ45/Network Cable Tester

To make a Patch Cable using CAT5/5e/6 first, using the cable stripper on the crimp tool, strip about 25mm of the outer jacket to reveal the 4 twisted pairs being careful not to damage the twisted pairs.  A Stanley knife can also be used if the crimp tool does not have a cable stripper. 

Arrange the four twisted pairs as follows from left to right:  Orange White, Orange, Green White, Blue, Blue White, Green, Brown White, Brown. 

Straighten the pairs as much as possible whilst keeping them arranged correctly.  Once the pairs are straightened, trim them down to about 10mm, or enough to allow the RJ45 Wedge to grip the Cable Jacket when crimped, and insert into your RJ45 Plug with Orange White being in Pin Terminal One, Orange being in Pin Terminal Two, Green White in Pin Terminal Three and so on, making sure each of the pairs go into the correct Pin Terminal.

You can now use you crimp tool to crimp the RJ45 Plugs pins into the pairs and the RJ45 Plug wedge onto the jacket of the Cable.

RJ45 pins and pair arrangement shown below

 

After crimping your RJ45 Plugs to each end of your CAT5/5e/6 Patch Cable you’ll need to test the cable to make sure it will work correctly. An RJ45 Tester will test the Patch Cable and indicate if there are any problems with your cable.

If there is an issue with the Cable you’ve made the tester will indicated which end and which pin isn’t working correctly.

X